Fischer Wall Holder FLH 40x150x3/11/F-SP AL (Pack of 50)

About this product

Product code: 548062

The L-wall holder of the BWM subframe system ATK 100 made of aluminium is the basis for a façade subframe. It is fastened to the building substrate using fischer fixings. To reduce thermal bridges, thermostops made of hard-PVC can be attached to back of the wall holders. In order to enable all common insulation thicknesses and façade offsets, the wall holders are designed and manufactured in different projection lengths. To allow the thermal expansion of the profiles, the wall holders are used both as fixed and sliding points. The fixed point absorbs the entire dead loads of the façade panels and subframe system in addition to the proportional wind loads. With its slotted holes, the sliding point also ensures that the vertical profile can slide due to thermal expansion. The sliding point is also used to transfer wind loads. These fixed/sliding points suit both applications.

The L-shaped geometry of the wall holder ensures optimised load transfer

The combination of wall holder and vertical profile ensures optimum compensation of tolerances in the building substrate

Compatible with all common fixings and connectors (e.g. fischer frame fixings and steel anchors)

The predesigned hole pattern allows for quick and easy installation

Flexible adjustment of the vertical profile possible due to innovative helping hand clip on the wall holder

Absorption and transfer of the occurring wind and dead loads of the façade system

Compensation of construction tolerances possible

Including perforation for optional helping hand clip

Optimized for 11mm fixings, e.g. for anchoring in concrete

Compatible with pressure disk for high loads

Applications:

As an angular L-shaped wall holder made of aluminium for the vertical subframe system ATK 100

For load transfer into the building substrate of subframe systems in ventilated rainscreen façades

Specifications:

Length (L): 40 mm

Width (W): 40 mm

Height (H): 150 mm

Thickness (T): 3 mm

Dimensions (d): 11x20 mm

Hole pattern: 3x 11x20 mm

Hole pattern profile: 5x 5.1 / 2x 5.5x25 mm

Angle: 90°

*Packaging on these products may be damaged or showing signs of wear and tear and may be reboxed but all products are in good working condition. These products are non-returnable and non-refundable and once they are gone they are gone.